轻钢别墅_自建房论坛门户网站_建房迷

 找回密码
 立即注册

QQ登录

只需一步,快速开始

用新浪微博登录

只需一步,快速搞定

易构pvc挂板施工指南中英文对照表-轻钢别墅外墙PVC挂板安装手册

2016-12-22 21:49| 发布者: 乌龟| 查看: 768| 评论: 11|原作者: Robin_zeng

摘要: 易构pvc挂板施工指南中英文对照表 欢迎下载传阅! 有任何问题可以询问: 0571-89007407 同时也欢迎建房迷们采购易购的PVC挂板,我们的产品在建房迷轻钢自建平台可以查到 http://jianfangmi.com/diy/#cailiao ...
建房迷推荐产品,下单支持建房迷
易构pvc挂板施工指南中英文对照表
欢迎下载传阅!
有任何问题可以询问: 0571-89007407   

同时也欢迎建房迷们采购易构的PVC挂板,我们的产品在建房迷轻钢自建平台可以查到
http://jianfangmi.com/diy/#cailiao

QQ图片20161222215136.png

挂板安装程序,先安装附件(外角柱、内角柱、起始条、J 型 条 ),
再 安装挂板。在使用上,外墙挂板是一片紧扣另一片,紧密牢固,功能齐备
的各种附件使边缘节点的 处理完美无缺。常用的工具有:电锯(台式或手提
式)、手锤、细齿直形刀锯、直角尺、水平 尺、卷尺、墨线、保护眼镜、工
具刀、铁剪子;专用工具有打孔钳、冲孔钳。


1、弹定位线 Drew positioning line
安装挂板前,必须先弹好线。Before installation, must draw the line
 在建筑物的每个角,量 测从 屋檐到被挂板覆盖的最低点
At each corner of the building, Measurements from the roof to the covered
by the siding lows
(如:勒角或腰线顶面)的 距离。
 使用得到的最短距离值为基 准,沿墙面弹水平线。用这 条线作为起始条
的定位线。

注:确保起始线是水平的。
Using the shortest distance value as the base,Along the wall Draw a
horizontal line.(Note: to ensure that the starting line is
horizontal.)


2、起始条的安装 ( the installation method of Start Strip)
 沿建筑物的底部安装起始条,保证起始条的下边缘与定位线重合。
Along the bottom of the building installation the Start strip, ensure
the locating and the lower edge of the start of the line.  在起始条的每个需安装螺钉的孔中间,用记号笔作记号,并取下起始条。
Should be installed in the Start strip of each screw hole in the middle,
with a marker pen marked, and remove the Start strip.  在作记号处钻孔,将塑料胀管装人,再将起始条就位,在钻孔处钉槽中间
拧入螺钉。Drilling in marked place,In the plastic expansion tubes,Put
on Start article again,In the middle of the nail hole groove screwed
into the screw.  当对接起始条时,应使它们保持至少10 毫米的间距,防止膨胀所引起的
变形。When Start strip docking, should keep them at least 10 mm spacing,
prevent deformation caused by inflation.  起始条同外角柱和内角柱之间留下
足够的距 离,一般为75 毫米。
The start strip with the left 75 mm

distance between Outer corner and the
Inner Corner.  沿起始条上每400 毫米安装一个螺钉。
In the start strip point distance 400 mm installation of a screw.。


3、外角柱的安装 The installation method of Outer Corner
 外角柱应安装在距离顶部6 毫米处。
The Outer Corner should be installed at the top of the distance of 6 mm.  在最上面的钉槽的顶部固定螺钉。固定方法同上,也是先作好记号,装入
塑料胀管再将外 角柱就位,在钻孔处钉槽中间拧入螺钉。
On the top of the nail groove at the top of the screw.and Installation
method as well as starting strip
 每隔400 毫米安装一个塑料膨胀螺钉。An interval of 400 mm installation screw


4、内角柱的安装 内角柱的安装同外角柱一样。
注:当一个角柱长度不够,须用几个角柱搭接时,上面的角柱应搭接在下面的角柱之上。并
将下面的角柱边缘 剪去25 毫米。
The installation method of Inner Corner is as well as Outer Corner .
(NOTE:When a Outside the prism length is not enough, must use two
this,ON Angle should be above the lap joint Angle below. And cut to
25 mm below the edge Angle).



5、门和窗周围的安装 Around the doors and Windows installation method
 窗子四周用 J 型条安装。根据挂板切割的位置,可能需要在J形槽下安装垫片,使J形槽和外
墙挂板在同一平面。Around the window using the J-Strip installation.May according
to need in the J-Strip groove, the installation gaskets, make J groove and siding
in the same plane.  安装圆弧窗时,J形槽事先需加热并弯成同窗
一样的弧度。
when Installing a circular window, J-Strip tank prior to heating and bending into as
the radiant of the circular window.  门的安装方法和窗子相同。
Door installation method is the same as the window.  阳台板、空调台板周围J形槽的安装同窗。The balcony board, the installation of air
conditioning bedplate J-Strip around the same as the window


6、墙体顶部的安装 在安装挂板前,同样应将山墙顶部的J形槽安装好。在山墙顶端,J形槽交会
处,应切45 度角。
Before wall top mounted Siding, should first J-Strip of the tank is installed.
At the top of the mountain, the J-Strip (J 形槽) of groove intersection, should cut
45 degree Angle.



7、挂板的安装 Siding Installation attachment
 将第一层外墙挂板安在起始板条上,紧紧地咬合。
The first layer of Siding installed on the Start Strip, Siding and Start Strip must be
fastened up.  在外墙挂板板端与角柱及门窗边缘J形槽之间预留6毫米的距离。On the edge of the Siding
both ends with the Outer Corner and the doors and Windows reserved 6 mm distance
between J-Strip .  两块板端应该搭接,搭接长度大约为工厂预制槽的一半(搭接时注意当地的常年风向)。
Two boards should end lap, lap length about half the prefabricated groove for the factory.
(Lap when pay attention to the local for the direction of the wind)
 为了美观,每层挂板搭接部分最少互相错开1米,这样一个搭接不会直接在另一个之上。每
4 或 5 层,应 检 查 一 下外 墙 挂 板 是否 与 屋 檐 和窗 户 是 否 保持平行,是否
与其它墙面上的挂板在同一直线上。
In order to beautiful, each layer hangs Taiwan lap part least stagger 1 meter each other,
such a lap doesn't directly upon another.When installing siding, often should check the
siding parallel to the roof and Windows.

 当外墙挂板被固定好以后,不要用力向上或向下推它。
When the siding is fixed, not to push it up or down hard.  通常,搭接的部分应远离出入口和交通频繁的位置。这样会改善安装的整体外观。
Usually part of the lap joint should be far away from the position of the entrances and
frequent traffic. This will improve the installation overall appearance.


8、山墙边端的安装 The top of the mountain type wall installation method
 斜切外墙挂板来安装没有被覆盖的部分。
Cant cutting wall hangs Taiwan to install is not a part of the cover.
五 、 O f t e n m e e t w i t h t h e i n s t a l l a t i o n o f d i f f e r e n t w a l l g r a p h i c
1、窗眉 Window brow、窗套 Window Casting、窗台 windowsill 处节点 →

2、穿墙管道处节点
3、门头节点

4、腰线处节点
5、墙面突出物

6、女儿墙节点
六、安装时的注意事项 The matters needing attention during installation
 除竖向构件的最上面一个螺钉应位于钉槽的顶端外,其余螺钉均钉在钉槽的中间
In addition to the vertical component of the top a screw should be fixed on the top
of the nail groove, the rest of the screws are in the middle of the nail groove.  螺钉不要拧得太牢。考虑到挂板的胀缩,钉帽同挂板之间留0.8毫米的距离。 当挂板被固定
以后,用手按住挂板,应该能够左右移动。
Screw don't too fast. Considering the swell-shrink siding, head of nail with siding
between the distance of 0.8 mm. When siding are fixed with the hand holding the siding,
should be able to move around.



 螺钉不能直接钉在挂板面上。如果没有钉槽,用钉眼冲孔器做一个。
Screw can not directly on the siding. If there is no nail groove, made a nail hole
punching machine.  螺钉要垂直钉入。不要使钉子弯曲,否则会限制挂板自由移动。如果钉得偏上或偏下,挂
板可能会被偏离校准直线。
Screw must be vertical nail into. Don't bend, otherwise it will limit siding move freely.
 每安装完一片挂板,检查挂板下边是否与下一层挂板扣牢,且不要太松或太紧。
When installed a Siding, must check the underneath and the next layer of Siding lock-in,
not to be too loose or too tight.


部分截图

QQ图片20161222214847.png轻钢别墅外墙PVC挂板安装手册



QQ图片20161222214858.png
轻钢别墅外墙PVC挂板安装手册

QQ图片20161222214909.png
完整的PDF下载

乌龟,如果您要查看本帖隐藏内容请回复






易构PVC挂板安装演示 中英文对照.pdf


感觉内容还不错?赶快和你的小伙伴分享吧


鲜花

握手

雷人

路过

鸡蛋
发表评论

最新评论(反正不用登录,随便说几句呗)

Robin_zeng 2016-12-22 20:59
需要直接下载,欢迎考察指导!  0571-89007407
乌龟 2016-12-22 21:20
绝对的干货啊,谢谢分享
fanxiang633 2016-12-22 22:09
好好好好好
hygszz 2016-12-22 22:12
楼主
钢构房-阳光房 2016-12-22 22:59
manndy 2016-12-23 05:33
顶顶顶顶顶顶顶顶顶顶顶顶顶顶顶顶顶顶顶顶
fengjunwei 2016-12-23 07:46
谢谢分享,大家可以学习学习
苏尚11 2016-12-24 10:01
学习一下
kite78 2017-9-29 01:52
资料很好,值得学习
yufei 2017-9-30 17:55

绝对的干货啊,谢谢分享
77325 2017-10-1 16:26
使用寿命是多少年

查看全部评论(11)

相关阅读

在别的地方找到建房迷

  • 建房迷微信

    请搜索微信号:jianfangmi

微信群|Archiver|小黑屋|手机版|建房迷JianFangMi ( 沪ICP备05016077号-1沪公网安备 31011502007163号

GMT+8, 2020-9-10 22:41 , Processed in 0.107114 second(s), 32 queries .

Powered by Discuz! X3.1

© 2001-2013 Comsenz Inc.

返回顶部